
Service and Maintenance (cont.)
ENSURE THAT THE GAS/ELECTRICITY SUPPLIES TO THE APPLIANCE HAVE BEEN TURNED OFF, BEFORE
REMOVING OR DISMANTLING ANY CONTROLS.
Removing the Thermostat. (Section 1)
1) Remove the top cover from the control panel by undoing the twelve fixing screws.
Fig. 1
2) Slacken grub screw and pull off the control knob (A).
3) Disconnect the wiring (B), noting their positions.
4) Remove the two screws (C) and withdraw thermostat body (D) from the control panel.
5) Release control panel assembly from the oven by removing four screws (E) and washers.
Fig. 2
6) Release top plate (A) from oven by removing six screws (B).
7) Remove all the oven furniture. Remove five screws (C) and withdraw air scoop (D) from right-
hand rear of oven.
8) The thermostat phial may now be unclipped from rear of oven and unthreaded through oven
roof.
9) Replace by reversing the above procedure.
ENSURE THAT THE THERMOSTAT PHIAL IS NOT KINKED - HAS NO SHARP
BENDS AND IS CORRECTLY LOCATED IN ITS HOLDER.
Fig. 1 Fig 2
Manual Part No: 930087-01 SNORKEL Gas Convection Oven - 29 –
Manual Rev No: 1
Commentaires sur ces manuels